Table of Contents
Advertisement
About the GNX3000
GNX3000 Owner' s Manual
While the tuner is selected, you can set your tuning reference with the DATA WHEEL.
The default factory setting is A=440 Hz. The tuning references range from 427 Hz to
453 Hz (± 50 cents (1/2 semitone) from either direction of 440 Hz). Below 427 Hz, are
alternate dropped tunings. The alternate tunings are REF A(A=Ab), REF G(A=G),
and REF G(A=Gb). The display window briefly flashes the selected tuning preference.
Footswitch Modes
When you first apply power to the GNX3000, it powers up in one of three Footswitch
Modes: Preset, Stompbox, or Record/Drum. The Footswitch Modes are selected in two
different ways:
Press the MODE button (located to the right of the DATA WHEEL)
OR
Press and hold FOOTSWITCHES 4 and 5 simultaneously.
Depending on which mode is selected, the DOWN/UP FOOTSWITCH LEDs will light a
different color. When Preset Mode is selected, these footswitches will be lit green. When
Stompbox Mode is selected, these footswitches will be lit yellow. And when Record/
Drum Mode is selected, these footswitches will be lit red. In any of the modes, the
display shows the selected preset's name and number. The vertical LEDs on the Matrix
indicate which effects are active for the selected preset.
Preset Mode
The GNX3000's Presets are grouped into thirteen banks of five presets. When
Preset Mode is active the DOWN/UP FOOTSWITCHES are used to select one of the
thirteen User, thirteen Factory 1, or thirteen Factory 2 Banks. Successive presses of
the DOWN/UP FOOTSWITCHES advance through all User/Factory Banks. Pressing
and holding the DOWN/UP FOOTSWITCHES scrolls through the User/Factory
Banks. Once a Bank is selected, FOOTSWITCHES 1-5 will flash indicating a preset
within that bank can be selected. If a preset is not selected within 5 seconds, the
GNX3000 returns to the currently selected bank and preset. A second press of an
active Preset's footswitch bypasses the preset. Another press reloads the preset.
For a list of presets, refer to page 133.
Preset Bounceback
Preset Bounceback is a great live performance feature that lets you switch
beween two presets with the same footswitch. For example, let's say you select
Preset 1 using FOOTSWITCH 1 as your rhythm tone. Then you select Preset 4
using FOOTSWITCH 4 as your solo tone. You can now press FOOTSWITCH 4
again and Preset 1 will be selected again. Pressing FOOTSWITCH 4 repeatedly
will bounceback between Preset 4 and Preset 1. To enable the Preset
Bounceback feature, do the following:
36
Advertisement
Table of Contents
