Guitar Signal Routing - DigiTech GNX3000 Owner's Manual

DRUMS mn
GNX3000 drum playback (summed to mono) up the USB 3 channel. Nothing
is sent up the USB 4 channel.
The following diagrams outline how the different input signals are routed through
the GNX3000 and out to computer (USB) for recording:

Guitar Signal Routing

The guitar signal is routed from the input through the GNX3000's effects
processing and then to the pairs of analog outputs. There are two paths in which
the guitar signal can be routed up the USB port to the computer. Path A taps the
guitar signal off at the input and sends unprocessed signal up the USB port. Path
C taps the guitar signal at the output of the GNX3000 and includes any effects
processing that may be used. Signals recorded from USB Send Path A can be
played back later through the GNX3000 for re-amping. See Re-Amping a Guitar
Track on page 114 for more information on how this feature works.
USB Dry A B USB Re-Amp
Send Path Return Path
Guitar Input
PICKUP SIM
Below is a matrix to show where the signal is tapped based on how the USB 1-2
Source and the USB 3-4 Source settings are configured.
Routing of Guitar Input to USB
Guitar C
C C
• = not recorded
Note: Speaker Compensation should be enabled on the XLR outputs when
recording guitar.
Routing of Mic Inputs to USB
WHAMMY/IPS
STOMPBOX
WAH COMP
(except TALKER)
= Speaker Compensation Module
SC
USB 1-2 Source
C
C, A C A • A •
USB 1-2 Source
CH 1 AMP
CH 1 AMP
WHAMMY/IPS
MODELING/ GATE
CABINET
(except TALKER)
TONE
CH 2 AMP
CH 2 AMP
MODELING/
CABINET
TONE
• Guitar
• • • A • A •
GNX3000 Owner' s Manual
USB Send C
Path
SC
CHORUS/
DELAY REVERB
MOD
SC
SC
SC
USB 3-4 Source
•
•
USB 3-4 Source
105
GNX3000 Owner' s Manual
D USB Playback
Return Path
XLR Left Output
XLR Right Output
1/4" Left Output
1/4" Right Output
(1/4" USB Playback
disabled in Split Modes)