Using Pro Tracks Plus Tm; Hands-Free Tm Recording Capabilities; Setting Up The Gnx3000 Midi Device; Setting Up The Gnx3000 For Hands-Free Recording - DigiTech GNX3000 Owner's Manual

Computer Recording via USB
GNX3000 Owner' s Manual
Using Pro Tracks Plus
When Pro Tracks Plus is first launched after installation, you will have to configure
the MIDI device and Audio settings to recognize the GNX3000 as the hardware you
want to use. These procedures must be followed to ensure you will be able to record
audio through all of the GNX3000's inputs and to enable the Hands-Free
capabilities the GNX3000 offers.
NOTE: Refer to the "Installing the GNX3000's Software Suite" section on page 101
before connecting the GNX3000 to the USB port on your PC and using Pro Tracks
Plus.
Hands-Free Recording Capabilities
TM
Pro Tracks Plus software must be installed on your computer in order to use
the recording capabilities of the GNX3000. To install Pro Tracks Plus, insert the
Software Install CD into your computer's CD-ROM drive and follow the on-
screen prompts.
Note: If Autorun is disabled on your computer, double-click on My Computer, then
double-click on your CD-ROM drive. When the installation program starts, follow
the on-screen prompts.

Setting Up the GNX3000 MIDI Device

The GNX3000 uses MIDI commands to communicate with Pro Tracks Plus. These
commands are used to determine which USB 1-2 Source and USB 3-4 Source
settings have been selected so that Pro Tracks Plus can function properly when
using the GNX3000's Hands-Free
Plus' MIDI settings for use with the GNX3000 follow the steps outlined below:
1. Start the Pro Tracks Plus application on your computer.
2. If the Tip of the Day window appears, click the Close button.
3. If no previous MIDI outputs have been selected, the No MIDI Outputs Selected
window will appear. Click the Choose MIDI Outputs Now button. The MIDI
Devices window will open.
4. Under both Input and Output Selections, choose DigiTech USB MIDI. Do not
select DigiTech USB X-Edit or any other available selections. Click the Move
Selected Devices to Top button.
5. Click the OK button and the window will close.
6. If the Quick Start window appears, click the Close button.

Setting up the GNX3000 for Hands-Free Recording

1. From the Pro Tracks Plus menu bar, select Options>Control Surfaces. The
Control Surfaces window will appear.
108
TM
recording features. To configure Pro Tracks
TM
recording
TM