Table of Contents
Advertisement
Selecting Amps and Cabinets
The first step to editing an Amp/Cabinet model, or creating your own
HyperModel
is to select the Amp and Cabinet model for Channel 1 and
TM
Channel 2 in your preset. The procedure for selecting Amps or Cabinets is as
follows:
1. Press the GENETX AMP CONTROL button.
2. Use KNOB 1 to select the Amp for Channel 1. The Amp name appears in the
display. (See page 44 for a complete list of Amp Models.)
4. Use KNOB 2 to select the Cabinet for Channel 1. The Cabinet name appears in
the display. See page 46 for a complete list of Cabinet Types.)
5. Use KNOB 4 to select the Amp for Channel 2. The Amp name appears in the
display.
6. Use KNOB 5 to select the Cabinet for Channel 2. The Cabinet name appears in
the display.
Adjusting Amp Parameters
The Gain, EQ, and Level Parameters can be adjusted individually for Channel 1
and Channel 2. This is accomplished by pressing the TONE Amp Control button.
The sound that you hear while adjusting the knobs depends on the state of the
STATUS button and the KNOBS (see chart below). When the TONE row is selected,
the STATUS button steps through four states in the following order:
-
The STATUS button LED lights green and the five control knobs
Ch1 amp
light green indicating that you are listening to Channel 1 and the
control knobs affect Channel 1's tone settings.
-
The STATUS button LED lights yellow and the five control knobs
Ch1 warp
light green indicating that you are listening to a warped sound
and the control knobs affect Channel 1's tone settings.
-
The STATUS button LED lights red and the five control knobs
Ch2 amp
light red indicating that you are listening to Channel 2 and the
control knobs affect Channel 2's tone settings.
-
The STATUS button LED lights yellow and the five control knobs
Ch2 warp
light red indicating that you are listening to a warped sound and
the control knobs affect Channel 2's tone settings.
The Gain ranges from 0 (
from -12 dB (
) to +12dB (
-12
procedure for adjusting these parameters is as follows:
1. Press the TONE Amp Control button.
2. Press the STATUS button to select either Channel 1 Amp (Green) or Channel 2
Amp (Red).
3. Use Knobs 1 through 5 to adjust the Gain, Tone, and Level of the selected amp
channel.
) to 99 (
). The Bass, Midrange, and Treble EQ range
0
99
). The Level ranges from 0 (
12
GNX3000 Owner' s Manual
) to 99 (
). The
0
99
47
GNX3000 Owner' s Manual
Advertisement
Table of Contents
