Curve, Prog. Mixes 5-8 - FUTABA 10CAG Instruction Manual

CURVE PROGRAMMABLE MIXES ( PROG.MIX5-8 )( HELI : PROG.MIX5-6 ):
Your 10CG's ACRO GLID programs contain four separate curve programmable mixes. HELI contains two. There are a variety
pre-programmed curve mix is the THROTTLE-NEEDLE function. This curve is adjustable at 5 points, allowing you to adjust
the motor's tuning at 5 points along its RPM range.
One programmable curve mix defaults to RUDDER-AILERON . A linear mix that keeps the model from rolling in knife-edge is
mix. Inhibit the linear mix, then adjust the curve to get the right response all along the rudder channel's travel.
• ACRO GLID Defaults: The 4 programmable curve mixes default to the most frequent choices, but can be set to any channel.
• PROG.MIX5 rudder-to-aileron for roll coupling compensation ( GLID mixes default to aileron-to-elev.)
• PROG.MIX6 rudder-to-aileron for roll coupling compensation ( GLID mixes default to aileron-to-elev.)
• PROG.MIX7 rudder-to-elevator for pitch coupling compensation ( GLID mixes default to elevator-to-airbrake.)
• PROG.MIX8 rudder-to-elevator for pitch coupling compensation ( GLID mixes default to elevator-to-airbrake.)
• HELI Defaults:
• PROG.MIX5 aileron-to-elevator for coordinated turns
• PROG.MIX6 aileron-to-elevator for coordinated turns
• Master: The controlling channel can only be a channel. Cannot be OFFSET or dial.
• Trim: not available in curve mixes.
• Offset: not available in curve mixes.
71