Table of Contents
Advertisement
Program. mixes
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also
be used for unusual control con昀椀gurations. Mixing
means that the motion of a command channel,
called the "master," is added to the motion of the
mixed channel, called "slave."
You may choose to have the Masters trim added to
the Slave channel response, if you desire ("Trim"
setting). The mixing curve can be changed so
that the undesired tendencies can be corrected
e昀昀ectively by setting the EXP1/EXP2/Point modes.
● Tap the [Prog. mixes] button in the Model menu to call
the setup screen shown below.
●Return to Model menu
After this function is
activated, the master
and slave function
names (or o昀昀set mixing)
are displayed.
Activate the function by
tapping the [INH] .
The ON/OFF switch of
prog. mixes is chosen.
Master function
(or Stick, Switch, Dial)
is chosen.
Slave function is chosen.
Servo speed setting
Program mixing which can be freely customized. Up to 10
mixings can be used for each condition. [All model types]
O昀昀set-type mixing applies a 昀椀xed o昀昀set or preset
to the programmed channel servo operation and
may control up to four circuits simultaneously.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with
other programmable mixing functions. The link
function can be set up for Master and Slave channel
individually.
Mixing/O昀昀set mode
switch
Trim mode setting ON/OFF.
126
→
● Group/single mode
switch (Gr./Sngl)
(For more information,
see the description
at the back of this
manual.)
● Operation curve setting
(For a description of the
setting method, see the
description at the back of
this manual.)
Fine tuning trim
setting
The on time (start/stop
time) can be set up to 4
seconds. It is useful for
landing gear control of the
jet or scale plane, etc.
GO to TABLE OF CONTENTS
Advertisement
Table of Contents
