FUTABA 10CAG Instruction Manual page 91

GOAL of EXAMPLE:
Reverse servos as needed for proper
control operation. Ex: LEFT RUDDER
STICK results in leading edge of tail
rotor blades moving left. Reverse to
operate properly. P. 38.
Adjust Travels as needed to match
model's recommended throws (usually
listed as high rates).P. 39.
Activate THR-CUT . P. 98.
Set up throttle curve for normal. (Usually
changes will not need to be made prior
Set up collective pitch curve for normal
center of +5,end of +8 to +10 degrees of
2
blade pitch for aerobatics.
Set up revo. mixing for normal. (For
heading-hold gyros, inhibit revo.) P. 97.
GYRO programming for proper setup.
See p. 106.)
STEPS:
In the BASIC menu, open REVERSE .
Choose desired servo and reverse its
direction of travel. (Ex: reverse rudder
servo.)
In the BASIC menu, choose END POINT .
Adjust the servos' end points.
(Ex: elevator servo)
Return to BASIC menu.
Open THROTTLE-CUT function.
Activate the function. Choose desired
switch and position to activate.
With THROTTLE STICK at idle, adjust
the rate until the engine consistently
shuts off, but throttle linkage is not
1
binding.
Close.
Open the THR-CURV/NOR function.
Adjust if needed.
Close the function.
Open the PIT-CURV/NOR function.
Adjust each point to match desired
(If just learning Close the function.
Open the REVO./NOR function.
Adjust to your desired starting point.
(Ex: 10% .)
Close the function.
With radio on, move helicopter's tail to the right by hand.
The gyro should give right rudder input (leading edge of the tail rotor blades
move left).
If the gyro gives the opposite input, reverse direction on the gyro unit itself.
INPUTS:
C
C
Are you sure? Displays.
Repeat as needed.
C
C
Repeat as needed.
C
C
C
C
C
C
Repeat.
C
8% .)
Repeat.
C
Repeat.
91
to REVERSE .
to choose REVERSE .
to CH4:RUDD .
so REV is highlighted.
for 1 second.
to return to BASIC menu.
to END POINT .
to choose END POINT .
to ELEV .
ELEVATOR STICK.
until up travel is as desired.
ELEVATOR STICK.
until down travel is as desired.
to THROTTLE-CUT .
to choose THR-CUT .
to MIX to OFF .
to SW . to C .
to POSI . to DOWN .
C to down position.
THROTTLE STICK.
to RATE . until shuts off.
to THR-CURV/NOR . .
to 5% . C to next point.
to PIT-CURV/NOR . .
to 8% . C to next point.
to REVO./NOR . . C
to 10% . to next point.
C
C to 1 > .
C to 1 > .
to 1 > .