Changing Mode; Power Down Mode; Campac - FUTABA 10CAG Instruction Manual

Changing Modes ( TX SETTING ):
Throttle Reverse: THR-REV is a special function that reverses the entire throttle control, including moving the trim
functionality to the stick's upper half. To use THR-REV , CURSOR DOWN to THR-REV and turn the DIAL to REV . Turn the
transmitter off and back on. This change affects all models in the radio. ( GLID only): The separate THR-REV settings for each
model can be set. (See p.33)
Display language: can be selected the display language of the function name, etc. in each function menu. The screen reads
" LANGUAGE ". Change this to the desired language.
Area Selection (Frequency Range):
The T10CG transmitter has been designed to function in many countries. If you will be utilizing this transmitter in a
country other than France, please make sure that TM10-MODE is set to " GENERAL ". If, however, this transmitter will be
utilized in France, it must be set to " FRANCE ".
Power Down mode ( TM10 POWER MODE ):
Power Down Mode: To activate the "Power Down Mode" press DIAL and the home screen will appear. During this mode,
the RF power is reduced so the range test can be performed. In addition, when this mode is activated the blue LED on the
front of the transmitter starts blinking and the transmitter gives users a warning with a beep sound every 3 seconds.
The "Power Down Mode" continues for 90 seconds and after that the power will return to the normal level. To exit the
"Power Down Mode" before the 90 seconds, press DIAL again. This mode is available one time only so if you need to re-
use this function the transmitter power must be cycled and the "Power Down Mode" reset. NEVER
"Power Down Mode" is active.
Power Off Mode: To use the RF power off mode, CURSOR DOWN to OFF and press DIAL. During this mode, the RF
power is turned off. The blue LED on the front of the transmitter is turned off.
CAMPac Initializing Method and Data Conversion (T9C/T9CS to T10CG):
To initialize the CAMPac, CURSOR DOWN to "Yes" and press DIAL and the check display of "OK?" will appear. Press
DIAL again, the initializing of the CAMPac will start.
home screen will appear. See p.30 for the conversion method.
Hold down MODE and END keys while turning on the transmitter to enter the TX SETTING
menu.
Stick Mode: The screen reads " STK-MODE ". Use the DIAL to change this to the correct mode.
Note that this will NOT change the throttle and elevator rachets, etc. Those are mechanical
changes that must be done by a service center.
We have installed a special "Power Down Mode" for doing a ground range check. Hold down
DIAL while turning on the transmitter to call TM10 POWER MODE menu.
Insertion of a new CAMPac or a CAMPac containing data of a different transmitter type will
open EXT-MEMORY menu after turning the transmitter on.
CURSOR lever and then press DIAL and the
17