FUTABA 10CAG Instruction Manual page 22

Range Testing Your R/C System
It is extremely important to range check your models prior to each flying session. This enables you to ensure that
incorporates a system that reduces its power output and allows you to perform such a range check.
Power Down mode (TM10 POWER MODE):
We have installed a special "Power Down Mode" for doing a ground range check. To access
the "Power Down Mode" hold down the DIAL while turning on the transmitter. Doing so will
bring up TM10 POWER MODE menu.
To activate the "Power Down Mode" press DIAL and the home screen will appear. During this mode, the RF power is
reduced so the range test can be performed. In addition, when this mode is activated the blue LED on the front of the
transmitter starts blinking and the transmitter gives users a warning with a beeping sound every 3 seconds.
The "Power Down Mode" continues for 90 seconds and after that the power will go back to the normal level. To exit the
"Power Down Mode" before the 90 seconds, press DIAL again. This mode is available 1 time only so if you need to re-use
1. With the "Power Down Mode" on, walk away from the model while simultaneously operating the controls. Have an
walk approximately 30-50 paces from the model without losing control.
2. If everything operates correctly, return to the model. Set the transmitter in a safe, yet accessible, location so it will be
within reach after starting the engine or motor. Be certain the throttle stick is in the low throttle position, then start the
engine or motor. Perform another range check with your assistant holding the aircraft with the engine running at various
that the battery has been fully charged.
22