FUTABA 10CAG Instruction Manual page 113

ACRO GLID
slower speeds, make tighter loops or turns, etc. Not a pre-programmed mix. See Programmable mix. This is the default
setting of one mix in ACRO and GLID .
Elevator-to-pitch mix: ( HELI ) used to adjust pitch to counter the loss of angle of attack when elevator input is given. Not a
pre-programmed mix. See Programmable mix. This is the default setting of one mix in HELI .
ELEVON
elevator servos. .................................................................................................................................................................... 56
Elevons: two surfaces, one on each wing, which work as both ailerons and elevators. See ELEVON .
END BUTTON: control button used during programming to return to previous menu or close menu altogether.
END POINT : often abbreviated EPA. Adjusts the total travel in each direction of proportional servos regardless of their
control assignment. Ex: adjustment to AIL channel will adjust only the servo plugged into channel 1 even if being used
setting. .................................................................................................................................................................................. 39
Engine cut: see THROTTLE-CUT .
EPA: see END POINT .
........................................ 24
Exponential ( D/R , EXP ): adjustment to the relationship of STICK MOVEMENT to servo movement, typically used to soften
overly sensitive models around center. ................................................................................................................................ 42
®
FASST : Futaba Advanced Spread Spectrum Technology
FailSafe ( F/S ): sets servo positions when interference is encountered or signal is lost. Also includes Battery FailSafe
settings. ................................................................................................................................................................................ 50
FLAP1/2/3/4
Twin aileron servos and Twin elevator servos.
Flap-to-aileron mix: ( ACRO GLID ) used to create full span flap reaction in flight. Not a pre-programmed mix. See
Programmable mix. This is the default setup of one mix in GLID .
Flap-to-elevator mix: ( ACRO GLID
pre-programmed mix. See Programmable mix. This is the default setup of one mix in ACRO and GLID .
FLAPERON Twin
aileron servos. ...................................................................................................................................................................... 51
KNOB. May also be used as
FLAP-TRIM
Twin aileron servos. .................. 53
Fuel mixture control: ( ACRO HELI ) see THROTTLE-NEEDLE .
FUNC : function mode of TRAINER , allows student radio to use the computer programming for that channel in the master
TRAINER .
Gain: the responsiveness or amount of control given the gyro. On a high gain, the gyro is very active and overrides nearly
all other actions. Too high a gain may result in "wagging" at the surface as the gyro over-corrects repeatedly in each
direction. See GYRO SENS .
Gear doors: covers for retractable landing gear, may be operated separately from landing gear on some models. ............ 74
GLID : model type, glider. ...................................................................................................................................................... 75
Governor: electronic device that reads the speed at which the head is spinning, and adjusts the throttle servo to maintain
113