FUTABA 10CAG Instruction Manual page 109

The GV-1 controls throttle when it is active, so the throttle will not obey any FailSafe setting presets for throttle in the
and the throttle obeys the FailSafe throttle commands.
Expert Tip: Mounting the GV-1 to the counter gear instead of the fan
Setting example:
Governor Speed
RS1: OFF
RS2: 1400
RS3: 1700
*The relationship of the governor speed setting rS1~rS3 and the switch positions conforms to the table above.
*In throttle hold, always check that the governor is off.
*If the speed value rises when the cut switch is activated, reverse the " DIR " setting from UP to DOWN or vice versa.
GOAL of EXAMPLE:
S e t u p a G V- 1 g o v e r n o r t o u s e
b o t h c h a n n e l s i n t o t h e r e c e i v e r
and switch between the governor
settings automatically when changing
conditions. Consider setting the battery
FailSafe settings and other helpful
functions on the GV-1 itself.
Where next?
Switch Position
(Switch C or Cond.)
UP or NORM
CNTR or IDL1
DOWN or IDL2
STEPS:
O p e n a n d a c t i v a t e t h e GOVERNOR
function.
Activate the function.
Optional: change cut-off channel
to channel 8 and assign switch and
direction for on/off (channel 8).
Optional: change switch assignment to
select governor settings.
Ex: select switch that adjusts the
conditions.
Adjust governor speed settings per
switch position or condition as needed.
(Ex: defaults are fine.) Allows head
speed adjustment from transmitter.
Close the function.
GYRO : see p. 107.
Adjust FailSafe ( F/S ) settings (p. 50).
See p. 101.
POINT SWASH AFR : p. 42, 39, 95.
Rate (%)
Use up to 0%.
0
(Governor speed display reads "off".)
Speed adjusted by raising and lowering rate.
50
Speed adjusted by lowering rate.
100
INPUTS:
SWITCH.
109
Adjustment from Tx.
for 1 second.
(If BASIC ,
C to GOVERNOR .
C to MIX . to ACT .
to cut- CH to +CH8 .
C
C t o c u t - S W . t o d e s i r e d
C to SW .
to Cond .
C to each Cond position.
or as needed.
C to next Cond position. Repeat.
D/R , EXP and END
again.)