Acro Basic Menu Functions; Model Submenu: Model Select , Copy , Name - FUTABA 10CAG Instruction Manual

MODEL submenu: includes three functions that manage model memory: MODEL SELECT , MODELCOPY and MODELNAME . Since
these functions are all related, and are all basic features used with most models, they are together in the MODEL submenu of
the BASIC menu.
T10CG/T10C CAMPac data compatibility
The CAMPac data saved from a T10CG or conventional T10C transmitter can be used directly by a T10CG and T10C
transmitter. As for the data of functions added by the T10CG:
(T10C data -> T10CG): an initial value is set up at this time.
(T10CG data -> T10C): the function doesn't work regardless of the data.
T9C/T9CS CAMPac data conversion
CAMPac will be copied to model number"01" of the T10CG transmitter. As for the data of the function added by T10CG,
In addition, refer to p.17 for the initializing method of the CAMPac.
NOTE: When you choose a new model in the MODEL SELECT function, if the new
model is set to a different modulation, you must cycle the transmitter power to change
screen to remind you. Please note: You are still transmitting on the other modulation
until you affect this change.
GOAL:
Select Model #3.
N O T E : T h i s i s o n e o f s e v e r a l
functions for which the radio requires
Confirm proper modulation of new
model memory.
Where next?
MODEL SELECT : This function selects which of the 15 model memories in the
transmitter (or 33 in the optional CAMPac-
the model's name and an image of its type are indicated after its number. (Each
model memory may be a different model type from the other memories.)
Note: If you are using the optional CAMPac-16K, your choices in MODEL
SELECT and MODEL COPY will include 16-33, which are the model memories in
the CAMPac. You do not have to COPY from the CAMPac to the transmitter
prior to working with that model.
Although the CAMPac
transmitter cannot be used directly, it is possible to use it by the following method. Copying
the information to the model memory of a T10C transmitter. When using the CAMPac, the
information will be displayed. For example, as "01<-Pac 01." Press DIAL for 1 second in
this state and the check display of "Are you sure?" will appear. Press DIAL again, the data of
STEPS:
Open BASIC menu, then open MODEL
submenu.
Choose Model #3.
Close.
If 2.4G
NAME the model: see p. 32.
Change MODEL TYPE (aircraft, heli, glider): see p. 34.
Change modulation ( 2.4G-10CH or 2.4G-7CH ): see p. 35.
Utilize servo REVERSE : see p. 38.
Adjust END POINTs : see p. 39.
Set up IDLE-DOWN and THR-CUT for throttle management: see p. 40, 41.
INPUTS:
C
Are you sure? displays.
30
for 1 second.
(If ADVANCE ,
if required to MODEL .
to 3 .
for 1 second.
again.)