Throttle Curve - FUTABA 10CAG Instruction Manual

Throttle curve ( THR-CURVE )( ACRO ):
Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point ( -stk- ) can be moved to the left or right by turning the DIAL (up to
GOAL of EXAMPLE:
Base point: Adjust base point of throttle
curve until engine idles reliably.
-out- : output, servo position.
-stk- : curve point, stick position.
Next point:
This function adjust the throttle operation curve for optimum engine response to
throttle stick movement.
NOTE: If the throttle EXP function is activated, you can not use THR-CURVE
function simultaneously.
STEPS:
Open the THR-CURVE function.
Activate the function.
Optional: Assign the switch.
Optional: Move the curve point.
(Ex: point 3)
Optional: Delete the curve point.
And return the curve point.
(Ex: point 3)
Adjust the next point.
Close.
67
DIAL for one second alternately.
INPUTS:
for 1 second.
C to THR-CURVE .
C to MIX .
to point 1 ( -out- ).
C
throttle servo position.
to SW .
C
to point 3 ( -stk- ).
C
curve point to move to left or right.
C to point 3 ( -stk- ).
second to delete the curve point.
C to point 3 ( -stk- ).
second to return.
Repeat as needed.
(If BASIC , again.)
to ON .
to desired
to desired switch.
to desired
for one
for one