Flap Trim - FUTABA 10CAG Instruction Manual

Using FLAP-TRIM
(ACRO)
FLAP-TRIM assigns the primary flaperon control [defaults to VR(A)] to allow trimming in flight of the flap action of
FLAP-TRIM
changing the Flap Trim travel. (Note that there is only one setting, not independent settings for up and down travel.)
GOAL of EXAMPLE:
Add FLAP-TRIM to allow the model's
at any time during the flight,with a
maximum travel of 5%
travel set in FLAPERON .
Where next?
( ACRO GLID )
FLAP-TRIM is made active with AIL-DIFF , it will not have any effect. The ONLY function that allows
AIL-DIFF
STEPS:
Open the FLAP-TRIM function.
The function is automatically activated with FLAPERON ; however, the default
travel is 0 .
Adjust the travel available to the
f l a p e r o n s w h e n t u r n i n g t h e C H 6
DIAL.(Ex: 5% ).
Optional: Use as total flap control.
Reassign CH6 is primary control in
AUX-CH
(Ex: right slider)
Close menu.
Adjust individual servo's SUB-TRIMs : see p. 49 and END POINTs : see p. 39.
Set up AIRBRAKE mix: see p. 63 and ELEV-FLAP mix: see p. 62.
see p. 61.
View additional model setups on the internet: www.futaba-rc.com\faq\.
(GLID)
AIRBRAKE .) Most modelers use AIRBRAKE , or programmable
INPUTS:
C
C
53
for 1 second.
(If BASIC ,
to FLAP-TRIM .
to 5% .
to 50% .
C to AUX-CH .
to CH6 . to Vr-E .
again.)