Table of Contents
Advertisement
GOAL of EXAMPLE:
Adjust travels as needed to match
model's recommended throws (usually
listed as high rates).P. 39.
( D/R , EXP )
P. 42.
(Note that in the middle of the left
side of the screen is the name of the
channel and the SWITCH position
you are adjusting. Two or even three
rates maybe set per channel by simply
choosing the desired SWITCH and
programming percentages with the
SWITCH
to the left slider [VR(D)]. ( AUX-CH )
p. 46.
Where next?
STEPS:
In the BASIC menu, choose END POINT .
Adjust the servos' end points.
Close the function.
Choose D/R , EXP .
Choose the desired control, and set
the first (Ex: high) rate throws and
exponential.
Set the second (low) rate throws and
exponential.
Optional: change dual rate SWITCH
assignment. Ex: elevator to SWITCH G
with 3 positions.
In the BASIC menu, open AUX-CH .
Choose CH6
Change primary control to VR(D).
Change other channels as needed.
Return to the home screen.
(Other functions you may wish to set up for your model.)
TRAINER p. 47.
Multiple wing or tail servos. See wing types and tail types: p. 51, 56.
OFFSETS , BUTTERFLY ( AIRBRAKE
Retractable Gear, Smoke systems, kill switches, and other auxiliary channel
setups: p. 46.
Adjusting SUB-TRIMs to match servo centers: p. 49.
77
INPUTS:
C
to END POINT .
to choose END POINT .
C
to FLAP .
until travel as desired.
VR(A)
VR(A). Repeat as needed.
C
to D/R , EXP .
to choose D/R , EXP .
C
to CH> .
to choose CH>2 (elevator).
A to up position.
[Note screen reads ELEV
(UP) ]
C
to D/R .
ELEVATOR STICK.
ELEVATOR STICK.
(Normally the same for both directions.)
C
to EXP .
ELEVATOR STICK.
ELEVATOR STICK.
C
to D/R .
A to down position.
Repeat above to set low rate.
C
to SW .
to G .
G to center position.
Repeat steps above to set 3rd rate.
C
to AUX-CH .
to choose AUX-CH .
C
to CH6 .
to VR(D) .
Repeat as required.
to set.
to set.
to set.
to set.
Hide quick links:
Advertisement
Chapters
Table of Contents
