Using Twin Aileron Servos: Aile-2 - FUTABA 10CAG Instruction Manual

Using Twin Aileron Servos, AILE-2 ( ACRO GLID ):
Note that selecting CH6&5 or CH7&5 does NOT free up CH6 or CH7 to be used for other functions when using a receiver
with more than 5 channels. Both 5 and 6 ( FLAPERON
CH6 are already fully set up to operate as ailerons. Mix CH7 or CH8 (the second aileron servo on the other side) into
ailerons to function properly.]
GOAL of EXAMPLE:
Adjust the second aileron servo output
from CH6or7 to channels CH6&5 .
Allows twin aileron servo operation
with a 5-channel receiver.
Where next?
AILE-2 only tells the radio that you are using CH5 and CH6 ( FLAPERON ), or CH5
and CH7 ( AIL-DIFF ), not CH6 or CH7, as the second servo in FLAPERON or AILE-
DIFF . You still must activate and set up the FLAPERON AILE-DIFF function.
AILE-DIFF ) are dedicated to the FLAPERON or AILE-DIFF programming.
STEPS:
Open the PARAMETER submenu.
Select AILE-2 and change to CH6&5 .
Close menu.
Finish setting up FLAPERON or AILE-DIFF . see Twin Aileron Servos: p. 51.
View additional model setups on the internet: www.futaba-rc.com\faq\
55
INPUTS:
for 1 second.
(If ADVANCE ,
C to PARAMETER .
to AILE-2 . to CH6&5 .
C
again.)