FUTABA 10CAG Instruction Manual page 116

NORMAL : trainer mode that does not give student radio the computer programming features of the master radio. See
Trainer.
NT8S: standard transmitter battery pack. See Accessories.
NULL : not assigned or never changed. Ex: a mix which has a null switch assignment is always active, and can never be
OFFSET : ( HELI ) separate trim settings available to each idle-up (using CONDITION ) setting, or assigned to separate switches
from the condition switches. When offset is ON , movement of the trim levers adjusts the OFFSET , not the normal condition's
trims. .................................................................................................................................................................................. 102
......................................................................... 84
OFFSETs
Offset mix: mix that independently moves the slave servo a set percentage of its total throw, not in relation to any master.
See Programmable mix.
PA2: Pilot Assist. Optional onboard device that uses optical sensors to correct modelis orientation to upright.
ATL . ... 33
PARAMETER
Peak Charger: charger that automatically stops charging when the battery is fully charged (commonly called "peaked").
See Battery care and charging.
Piezo gyro: gyro that uses a piezo crystal to sense angular changes. See Gyros and Governors.
Pitch-to-rudder mix: see REVO .
PITCH CURVE : ( HELI
STICK
Adjusted to provide ideal blade response for various types of maneuvers being performed. For simplicity, the normal
condition's curve may be set in the BASIC ADVANCE menu. ..................... 99
PPM: Pulse Position Modulation. Type of signal transmission.
Programmable mix: used to cause specific servo responses to specific inputs separate from the basic control setups.
........................................................................................................ 68
............................................................................................................................................ 18
Rate: amount of control given. Ex: see Programmable mix.
RESET : to delete all data in the existing model only. User CANNOT erase all data in the radio. Only service center can do
so. Part of PARAMETER submenu. ......................................................................................................................................... 33
..................................................... 74
REVERSE : servo reversing. Used to reverse the direction of a servo to ease installation and set up. .................................... 38
Rudder-to-aileron mix: ( ACRO GLID ) used to counteract undesirable roll (roll coupling) that happens with rudder
input, especially in knife-edge. Gives proper aileron input to counteract roll coupling when rudder is applied. Not a
pre-programmed mix. See Programmable mix. This is the default programming for one linear and one curve mix in ACRO
and GLID .
Rudder-to-elevator mix: used to counteract undesirable pitch (pitch coupling) with rudder input, especially in knife edge
Programmable mix. This is the default programming for one curve mix in ACRO .
Rudder-to-throttle mix: ( HELI ) adds throttle to counter the added load from increasing pitch of the tail blades, maintaining
a constant head-speed with rudder. (This is a minor effect and is not critical in most helicopters.) Not a pre-programmed
mix. See Programmable mix.
116