FUTABA 10CAG Instruction Manual page 72

GOAL of EXAMPLE:
Set up a RUDD-ELEV curve mix on a
model that pitches down severely at
full rudder and not at all with minimal
rudder input, and pitches worse on right
rudder than left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON when SWITCH C is down.
LINK should be ON if model has twin
e l e v a t o r s e r v o s . O t h e r w i s e , LINK
remains OFF .
(Note that point 3 is 0%. Otherwise,the
elevator would be retrimmed when the
mix is active and no rudder input is
given.)
Where next?
STEPS:
Open an unused curve programmable
mix. (Ex: use PROG.MIX7 since it is
already set-up for RUDDER-ELEV .)
Activate the function.
Choose master and slave channels.
(Ex: do not change MAS or SLV ).
Set LINK as needed. (Ex: off)
Assign SWITCH and position.
(Ex: change from F to C , DOWN .)
Optional: set switch to STk-THR to
activate mix with THROTTLE STICK.
(See above for details.)
Optional: set switch position to NULL .
Makes mix active at all times. Not
compatible with STk-THR .
Set desired percent at the stick points.
(Ex: listed at left.)
Close menu.
Adjust servo END POINTs : see p. 39.
Set up AILEVATOR : see p. 57.
Set up linear programmable mixes, ex: RUDDER-to-Aux2 (twin rudder servos):see p.
68, or additional curve mix, ex: RUDDER-AILERON : see p. 71.
View numerous mix setups: www.futaba-rc.com\faq\
72
INPUTS:
for 1 second.
(If BASIC ,
C to PROG.MIX- .
C to 7 > .
to page 2.
to MIX . to ON .
C
already RUDD
already ELEV
C to SW . to C .
C to POSI . to DOWN .
C to SW . to STk-THR .
to POSI .
C
THROTTLE STICK to desired
point.
for 1 second to set.
to POSI . to NULL .
C
to page 1.
C to POINT-1 . to 25% .
Repeat for points 2-5.
again.)