FUTABA 10CAG Instruction Manual page 60

GOAL of EXAMPLE:
Activate SNAP-ROLL . Adjust elevator
travel to 55% , rudder travel to 120% in
snaps can not be performed when gear
is down.
snap to 105% .
(Note: using negative percents can
change any of the 4 snap directions. For
example, change snap 1 to "down" by
changing the elevator percent to -100% .)
Where next?
STEPS:
Open the SNAP-ROLL function.
SAFE-MOD so
Activate the function.
Adjust the travels as needed. (Ex:
elevator to 55% , rudder to 120% .)
Optional: Activate SAFE-MOD . [Ex:
ON when SWITCH E (10CAG) or
G (10CHG) is down, meaning snap
function is deactivated when that switch
is in the down position.]
Optional: Assign switches to up/down
and left/right. (Ex: Change to the left/
down snap and adjust rudder to 105% .)
Close menu.
Set up programmable mixes: see p. 61.
View additional setups on the internet:www.futaba-rc.com\faq\.
INPUTS:
C
C
C
C
Notice MIX reading is still OFF .
Notice MIX reading changes to ON .
C
C
Repeat steps above to set percentages.
60
for 1 second.
(If BASIC ,
to SNAP-ROLL .
to MIX . to OFF or ON .
to ELEV . to 55% .
to RUDD . to 120% .
E or G up. C to SAFE-MODE
to ON .
snap switch.
E or G down.
to SW1 . to A.
to SW2 . to B.
A down B down.
again.)