Dual Aileron Servos/Flaperons - FUTABA 6DA Instruction Manual

DUAL AILERON SERVOS/FLAPERONS

• Twin aileron servos are a very beneficial set up
which allows the modeler more precise control
and adjustment of the aileron response of the
model, as well as providing "flaperons" — the
movement of both aileron servos in the same
direction at the same time to act as flaps.
• Plug the right aileron servo into channel 1 and
the left aileron servo into channel 6. Notice
that moving the aileron stick moves only the
right aileron servo.
1. Plug each
aileron into the
proper channel.
CH 6
CH 1
2. Deflect
aileron stick.
BEFORE
3. only one
aileron moves.
• This radio cannot support two aileron servos on separate receiver channels AND a separate flap servo at the same time. If your model
requires both twin aileron servos and flaps, you must use a y-harness to drive the two aileron servos. Also note that this radio cannot
support a flaperon-to-elevator mix. If you have flaperons active, the flap-to-elevator pot sets up aileron differential, not a mix.
• Activate the flaperon feature with dip switch #9.
Note that both aileron servos now move with the
aileron stick. Check the servo direction for both
servos and adjust as required.
• The two aileron servos now operate in unison,
creating flap action when the flap knob is turned.
This feature is always active, so take care not to
move this knob accidentally in flight. See page
19 for instructions on using the flap control lever.
4. Activate
the Flaperon
dip switch.
AFTER
5. Both ailerons
should move when
the stick is deflected.
6. Move flap
knob when flap
is desired.
7. When the flap knob is moved, both
ailerons move down.
16
USING THE FREQUENCY BOARD
1. Stick the band number seal to the
frequency board.
2. Install the frequency board to the antenna.
3. Pass the frequency board over the small
part of the antenna and slide it to the
large part.
4. Cut off the unused side along the slot with
cutters, etc.
NON-SLIP ADJUSTABLE STICK LEVER
The length of the stick can be adjusted.
1. Unlock, the two heads, A and B, by turning them in the arrow directions.
2. Adjust the stick to the most comfortable length.
3. Lock the heads by turning them in the opposite direction of the arrows.
9