Toolbox; Safety Precautions When You Install Receiver And Servos - FUTABA 32MZ-WC Full Manual

Toolbox

adjustments that may be needed.
Hexagonal wrench (1.5 mm and 2.5 mm)
Tool for removing switch nuts.
Safety precautions when you install receiver and servos
Mounting the Servo
Wood screw
Rubber
grommet
Brass eyelet
Servo mount
(Airplane/Glider)
Servo lead wires
and fasten it at suitable points. Periodically check the
cable during daily maintenance.
Margin in the lead wire.
29
2.3-2.6mm nut
washer
Rubber
grommet
Brass eyelet
Servo mount
2.3-2.6mm screw
(Helicopter)
Fasten about 5-10 cm
from the servo outlet so
that the lead wire is neat.
Stylus pen
WARNING
Connecting connectors
Be sure to insert the connector until it stops at the deepest
point.
How to protect the receiver from vibration and water
Wrap the receiver with something soft such as foam rubber
to avoid vibration. If there is a chance of it getting wet, put the
receiver in a waterproof bag or balloon to avoid water.
Receiver's antenna
Never cut the receiver's antenna. Do not bind the receiver's
antenna with the cables for servos.
Locate the receiver's antenna as far as possible from metals
or carbon fiber components such as frames, cables, etc.
■ Cutting or binding the receiver's antenna will reduce the radio reception
sensitivity and range, and may cause a crash.
Servo throw
Adjust your system so that pushrods will not bind or sag
when operating the servos to the full extent.
■ If excessive force is continuously applied to a servo, the servo could be
damaged due to force on the gear train and/or power consumption
causing rapid battery drain.
Mounting servos
Use a vibration-proof rubber (such as rubber grommet) un-
der a servo when mounting the servo on a servo mount. And be
sure that the servo cases do not touch directly to the metal parts
such as servo mount.
■ If the servo case contacts the airframe directly, vibration will travel to and
possibly damage the servo.