Acro Basic Menu Functions; Model Submenu: Model Select , Copy , Name - FUTABA 10CAP Instruction Manual

MODEL submenu: includes three functions that manage model memory: MODEL SELECT , MODELCOPY and MODELNAME . Since
these functions are all related, and are all basic features used with most models, they are together in the MODEL submenu of
the BASIC menu.
Note: If you are using the optional CAMPac-16K, your choices in MODEL SELECT and MODEL COPY will include 16-19,
which are the model memories in the CAMPac. You do not have to COPY from the CAMPac to the transmitter prior to
working with that model
T9C/T9CS CAMPac data conversion
number"01" of the T10C transmitter. As for the data of a function added by T10C, an initial value is set up at this time.
In addition, refer to p.17 for the initializing method of the CAMPac.
NOTE: When you choose a new model in the MODEL SELECT function, if the new
model is set to the other modulation, you must cycle the transmitter power to change
screen to remind you. You are still transmitting on the other modulation until you
affect this change.
GOAL:
Select Model #3.
N O T E : T h i s i s o n e o f s e v e r a l
functions for which the radio requires
Confirm proper modulation of new
model memory.
Where next?
MODEL SELECT : This function selects which of the 15 model memories in the
number. (Each model memory may be a different model type from the other
memories.)
Although a CAMPac
cannot be used calling directly, it is possible to use it by the following method, copying to
the model memories of a T10C transmitter. When using the CAMPac, it will be displayed,
for example as "01<-Pac 01." Press DIAL for 1 second in this state and the check display of
"Are you sure?" will appear. Press DIAL again, the data of CAMPac will be copied to model
STEPS:
Open BASIC menu, then open MODEL
submenu.
Choose Model #3.
Close.
If PPM , PCM or 2.4G
modulation.
NAME the model: see p. 32.
Change MODEL TYPE (aircraft, heli, glider): see p. 34.
Change modulation [FM ( PPM PCM or 2.4G-10CH 7CH ]: see p. 35.
Utilize servo REVERSE : see p. 38.
Adjust END POINTs : see p. 39.
Set up IDLE-DOWN and THR-CUT for throttle management: see p. 40, 41.
CAMPac-
INPUTS:
C
Are you sure? displays.
30
for 1 second.
(If ADVANCE ,
if required to MODEL .
to 3 .
for 1 second.
again.)