C H A P T E R 4 Using The Cisco Unified Wireless Ip Phone 7925G Web Pages; Installing The Usb Drivers; Configuring The Usb Lan On The Pc - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Setting Up Your PC to Configure the Phones

Installing the USB Drivers

To install the drivers on your PC, perform the following steps:
Procedure
Step 1 Log into Cisco.com.
Download the installation package and "read me" file for the USB drivers from this location:
Step 2
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser-crypto
Note
Double-click on the USB-Install-7925.1-0-2.exe file to start the installation program.
Step 3
Follow the prompts in the InstallShield Wizard.
Step 4
Note
The driver installation is complete when you see the Finished screen. You can close the wizard.
Step 5
Plug the USB cable into the USB port on the PC and into the USB connector on the phone.
Step 6
The Found New Hardware Wizard dialog opens.
To update the new software, click the button next to Yes, this time only and click Next.
Step 7
Click the button next to Install the Software automatically (Recommended).
Step 8
After 2-3 minutes, the software installs and a message appears on the task bar stating "Found New
Hardware - Software installed and ready to use."
Click Finish when the installation is complete.
Step 9
The phone briefly displays "USB Connected" on the status line.

Configuring the USB LAN on the PC

To configure the USB LAN connection on your PC, follow these steps:
Procedure
To setup the USB LAN connection, do one of the following:
Step 1
•
•
Step 2 Locate and double-click the new LAN connection to open the Local Area Connection Status window,
then click Properties.
Scroll to the Internet Protocol (TCP/IP) section and click Properties.
Step 3
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
4-2
Before proceeding, review the "read me" file for specific instructions for your PC operating
system.
If you receive a Hardware Installation warning message stating that the software has not passed
Microsoft Windows Logo testing, click Continue.
For Windows XP—Click Start > Settings > Control Panel > Network Connections.
For Windows 2000—Click Start > Settings > Control Panel > Network and Connections.
Chapter 4 Using the Cisco Unified Wireless IP Phone 7925G Web Pages
OL-15984-01