Charge Phone Using Ac Power Supply; Cisco Unified Wireless Ip Phone 7925G Multicharger - Cisco 7925G Accessory Manual

Cisco Accessories

Charge Phone Using AC Power Supply

The following figure describes how you set up the phone to charge with the AC power supply. The numbers
refer to the procedure steps.
Figure 1: AC Power Supply
Procedure
Step 1 Lift the mini-USB port cover at bottom of phone.
Step 2 Swing the port cover to one side.
Step 3 Insert the AC power supply mini-USB connector in the port.
Step 4
Insert the AC plug adapter in the slot on the power supply.
Step 5 Insert the AC power supply in a wall outlet.
Step 6 Verify that the Indicator LED is red. Red indicates that the battery is charging. The LED turns green when
battery is charged.

Cisco Unified Wireless IP Phone 7925G Multicharger

The Cisco Unified Wireless IP Phone 7925G Multicharger can charge up to six phones and six batteries at
the same time, as shown in the following figure.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Accessory Guide
Charge Phone Using AC Power Supply
3