Pairing With Headsets - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 1 Overview of the Cisco Unified Wireless IP Phone 7925G
•
Handsfree devices may differ in how features are activated. Handsfree device manufacturers may also
Note
use different terms when referring to the same feature.
For more information on using handsfree features, see the documentation provided by the device
manufacturer.

Pairing with Headsets

The Cisco Unified Wireless IP Phone 7925G pairs with headsets by using a shared key
authentication/encryption method. This process requires confirmation of a PIN specific to the headset,
commonly "0000." The Cisco Unified Wireless IP Phone 7925G can be paired with more than one
headset at a time. Pairing is typically performed once for each headset used with the Cisco Unified
Wireless IP Phone 7925G. Once pairing is complete, the headset automatically connects to the
Cisco Unified Wireless IP Phone 7925G when both devices are powered on and in range.
The Cisco Unified Wireless IP Phone 7925G can only be connected to one Bluetooth-enabled headset at
Note
a time. Further, the Cisco Unified Wireless IP Phone 7925G only supports communication with
Bluetooth wireless technology-enabled devices qualified by the Bluetooth Special Interest Group (SIG).
Figure 1-1
functions of the keys on the phone.
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Three-way calling—When there is an active call and another incoming call or call on hold, you may
choose to handle the calls in one of two ways:
– End the active call and answer or resume a waiting call.
Put the active call on hold and answer or resume a waiting call.
–
shows the Cisco Unified Wireless IP Phone 7925G. The table that follows describes the
Bluetooth Technology
1-3