Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual page 85

Chapter 4 Using the Cisco Unified Wireless IP Phone 7925G Web Pages
Table 4-3
Item
Scan Mode
Call Power Save Mode Set for the type of power saving mode used in
802.11 Mode
Restricted Data Rate
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Basic Network Profile Settings (continued)
Description
Auto—Always scans when on a call. If idle
and signal strength is sufficient, the phone
does not scan.
Continuous—Always scans.
Single AP—Only scans at power on or if the
AP connection to the network is lost.
the WLAN. Options are:
U-APSD/PS-Poll
•
None
•
Determines the signal mode or priority for
selecting signal modes available in the WLAN.
Options are:
802.11 b/g—Use only 2.4 GHz band
•
802.11a—Use only 5 GHz band
•
Auto, 802.11b/g preferred over 802.11a
•
(dual band)
Auto, 802.11a preferred over 802.11b/g
•
(dual band)
The preferred band, if available, will
Note
be used at power-on, but the phone
may switch to the less preferred 2.4
GHz band, if available, and the
preferred band is lost. Once the phone
has connected to the less preferred
band, it will not scan for the preferred
band if the current band is acceptable,
and may remain connected to the less
preferred band.
Auto, signal strength (RSSI)—Use
•
strongest signal in dual band environment
Enables or disables the restriction of the
upstream and downstream PHY rates
according to CCX V4 Traffic Stream Rate Set
IE (S54.2.6). The default is disabled.
Configuring Network Profiles
For More Information, See...
Associating to APs,
page 2-12
802.11 Standards for WLAN
Communications, page 2-3
802.11 Standards for WLAN
Communications, page 2-3
—
4-9