Best Practices; Assigning The Wavelink Server; Assigning The Wavelink Server From The Phone - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Best Practices

Best Practices
This section describes the best practices recommended for setting up and using the Cisco Unified
Wireless IP Phone 7925G CU on the Wavelink Avalanche server.
•
•
•
•
•

Assigning the Wavelink Server

If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually
assign it.
Do not perform this task if you previously configured the Wavelink server address using DHCP Option
Note
149.
To assign the Wavelink server on the phone, choose one of the following methods:
•
•

Assigning the Wavelink Server from the Phone

To assign the Wavelink server from the phone, follow these steps:
Procedure
Turn on the phone and verify that it is installed with the required firmware version and is registered to
Step 1
Cisco Unified Communications Manager.
Choose SETTINGS > System Configuration > Wavelink.
Step 2
Unlock the phone by pressing **#.
Step 3
In the Alternate Wavelink Server option, choose Yes.
Step 4
Enter the IP address of the Wavelink server, and press Save.
Step 5
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
6-2
Ensure that the phone is registered to Cisco Unified Communications Manager.
Try out this process with one or two phones before deploying to many phones.
Set up a VLAN that only has access to the Wavelink server.
Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this
option, see Assigning the Wavelink Server from the Phone, page
Configure a Cisco Access Point to use a default SSID of "cisco" with open authentication and no
encryption.
Assigning the Wavelink Server from the Phone, page 6-2
Assigning the Wavelink Server using the Phone Web Page, page 6-3
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
6-2.
OL-15984-01