Configuring Trace Settings - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 4 Using the Cisco Unified Wireless IP Phone 7925G Web Pages

Configuring Trace Settings

You can use the Trace Settings area on the web page to configure how the phone creates and saves trace
files. Because trace files are stored in the memory of the phone, you can control the number of files and
the data that you want to collect.
When preserving trace logs, choose only the logs that need to be saved after the phone is powered off
Note
and powered on to avoid using up phone memory.
To display the Trace Settings area, access the web page for the phone as described in the
Phone Web Page" section on page
To change the trace settings for the phone, follow these steps:
Procedure
On the phone web page, choose the Trace Settings hyperlink.
Step 1
Step 2 In the Number of Files field, choose the number of trace files to save, from 2 to 10.
Step 3 In the Remote Syslog Server area, check the box to enable a server to collect the trace files.
Step 4 If you enabled the syslog server, then you must complete these fields:
•
•
In the Module Trace Level area, check only the modules for which you want data:
Step 5
•
•
•
•
•
•
•
•
•
•
Step 6 In the Advanced Trace Settings area, in the Preserve Logs field, choose one of the following:
•
•
Note •
•
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
IP Address—Enter server IP address
Port—Enter a port number (514, 1024-65535)
Kernel
Wireless LAN Driver
Wireless LAN Manager
Configuration
Call Control
Network Services
Security Subsystem
User Interface
Audio System
System
True—Save the trace logs to flash memory on the phone.
False—Save the trace logs to RAM.
When set to False, the trace logs are lost when the phone is powered off.
When the phone is powered off, then powered back on, the Preserve Logs field is reset to False, the
default value.
Table 4-8 describes these configurable items.
4-3, and then click the Trace Settings hyperlink under Setup.
Configuring Trace Settings
"Accessing the
4-27