Device Support; Safety Information - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
For additional instructions and conceptual information about Cisco Unified Communications Manager,
refer to Cisco Unified Communications Manager Administration Guide and to Cisco
Unified Communications Manager System Guide.
Related Topics
•
•
•

Device Support

Cisco Unified Communications Manager Release 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, and 7.0(1) require a device
package or service release update installed to enable device support for the Cisco Unified Wireless
IP Phone 7925G. Device packages including support for the Cisco Unified Wireless IP Phone 7925G are
available at http://www.cisco.com/kobayashi/sw-center/sw-voice.shtml.

Safety Information

Review the following warnings before installing the Cisco Unified IP Phone. To see translations of these
warnings, refer to the
Phone 7920G and Peripheral Devices
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
Warning
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning This equipment will not be able to access emergency services during a power outage because of
reliance on utility power for normal operation. Alternative arrangements should be made for access
to emergency services. Access to emergency services can be affected by any call-barring function of
this equipment.
Warning Do not use the Cisco Unified Wireless IP Phone 7925G in hazardous environments such as areas
where high levels of explosive gas may be present. Check with the site safety engineer before using
any type of wireless device in such an environment.
The plug-socket combination for the battery charger must be accessible at all times, because it
Warning
serves as the main disconnecting device. Statement 1019
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Adding Phones with Auto-Registration, page 3-3
Adding Phones with Auto-Registration and TAPS, page 3-3
Adding Phones with BAT, page 3-4
Regulatory Compliance and Safety Information for the Cisco Unified Wireless IP
document that accompanied this device.
Before You Begin
3-5