Firewall Default Rule (Bridge Mode); Figure 126 Security > Firewall > Default Rule (Bridge Mode) - ZyXEL Communications ZYWALL 2 PLUS User Manual

Table 50 SECURITY > FIREWALL > Default Rule (Router Mode) (continued)
LABEL
Apply
Reset

11.8 Firewall Default Rule (Bridge Mode)

Click SECURITY > FIREWALL to open the Default Rule screen.
Use this screen to configure general firewall settings when the ZyWALL is set to bridge mode.
See Section 11.1 on page 181
Figure 126 SECURITY > FIREWALL > Default Rule (Bridge Mode)
ZyWALL 2 Plus User's Guide
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
for more information about the firewall.
Chapter 11 Firewall
193