ZyXEL Communications ZYWALL 2 PLUS User Manual page 651

Table 239 Firewall Commands (continued)
FUNCTION
Delete
ZyWALL 2 Plus User's Guide
COMMAND
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask>
config edit firewall set <set
#> rule <rule #> destaddr-
range <start ip address> <end
ip address>
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#>
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#>
config delete firewall e-mail
config delete firewall attack
config delete firewall set
<set #>
config delete firewall set
<set #> rule<rule #>
Appendix H Firewall Commands
DESCRIPTION
This command sets a rule to have the
ZyWALL check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
This command sets a rule to have the
ZyWALL check for traffic going to this range
of addresses.
This command sets a rule to have the
ZyWALL check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the
ZyWALL check for TCP traffic with a
destination port in this range.
This command sets a rule to have the
ZyWALL check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the
ZyWALL check for UDP traffic with a
destination port in this range.
This command removes all of the settings for
e-mail alert.
This command resets all of the attack
response settings to their defaults.
This command removes the specified set
from the firewall configuration.
This command removes the specified rule in a
firewall configuration set.
651