Figure 315 Menu 11.1: Remote Node Profile For Pppoe Encapsulation - ZyXEL Communications ZYWALL 2 PLUS User Manual

Chapter 33 Remote Node Setup

Figure 315 Menu 11.1: Remote Node Profile for PPPoE Encapsulation

33.3.2.1 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for
obvious reasons. However, some vendor's implementation includes a specific authentication
protocol in the user profile. It will disconnect if the negotiated protocol is different from that in
the user profile, even when the negotiated protocol is stronger than specified. If you encounter
a case where the peer disconnects right after a successful authentication, please make sure that
you specify the correct authentication protocol when connecting to such an implementation.
33.3.2.2 Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic
demand. The ZyWALL does two things when you specify a nailed-up connection. The first is
that idle timeout is disabled. The second is that the ZyWALL will try to bring up the
connection when turned on and whenever the connection is down. A nailed-up connection can
be very expensive for obvious reasons.
Do not specify a nailed-up connection unless your telephone company offers flat-rate service
or you need a constant connection and the cost is of no concern.
The following table describes the fields not already described in
490
Menu 11.1 - Remote Node Profile
Rem Node Name= ChangeMe
Active= Yes
Encapsulation= PPPoE
Service Type= Standard
Service Name=
Outgoing:
My Login= 12356598@hinet.net
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Press ENTER to Confirm or ESC to Cancel:
Route= IP
Bridge= Yes
Edit IP= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedules=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Edit Traffic Redirect= No
Table 189 on page
ZyWALL 2 Plus User's Guide
488.