Firewall Default Rule (Bridge Mode); Figure 144 Security > Firewall > Default Rule (Bridge Mode); Table 70 Security > Firewall > Default Rule (Bridge Mode) - ZyXEL Communications ZYWALL 35 User Manual

Chapter 11 Firewall

11.8 Firewall Default Rule (Bridge Mode)

Click SECURITY > FIREWALL to open the Default Rule screen.
Use this screen to configure general firewall settings when the ZyWALL is set to bridge mode.
See Section 11.1 on page 243
Figure 144 SECURITY > FIREWALL > Default Rule (Bridge Mode)
The following table describes the labels in this screen.
Table 70 SECURITY > FIREWALL > Default Rule (Bridge Mode)
LABEL
0-100%
Enable Firewall
258
for more information about the firewall.
DESCRIPTION
This bar displays the percentage of the ZyWALL's firewall rules storage space that
is currently in use. When the storage space is almost full, you should consider
deleting unnecessary firewall rules before adding more firewall rules.
Select this check box to activate the firewall. The ZyWALL performs access control
and protects against Denial of Service (DoS) attacks when the firewall is activated.
Note: When you activate the firewall, all current connections through
the ZyWALL are dropped when you apply your changes.
ZyWALL 5/35/70 Series User's Guide