Figure 258 Logs > Reports; Table 132 Logs > Reports - ZyXEL Communications ZYWALL 2 PLUS User Manual

Internet security appliance

Hide thumbs Also See for ZYWALL 2 PLUS:

Table of Contents

Chapter 24 Logs Screens

Figure 258 LOGS > Reports

Enabling the ZyWALL's reporting function decreases the overall throughput by

about 1 Mbps.

The following table describes the labels in this screen.

Table 132 LOGS > Reports

Traffic Statistics

Select the check box and click Apply to have the ZyWALL record report data.

Select the check box and click Apply to have the ZyWALL send unprocessed traffic

statistics to a syslog server for analysis.

You must have the syslog server already configured in the Log Settings screen.

Click Apply to save your changes to the ZyWALL.

Click Reset to begin configuring this screen afresh.

Select on which interface (LAN, DMZ or WLAN) the logs will be collected. The logs

on the DMZ, LAN or WLAN IP alias 1 and 2 are also recorded.

Use the drop-down list box to select the type of reports to display.

Web Site Hits displays the web sites that have been visited the most often from the

LAN and how many times they have been visited.

Protocol/Port displays the protocols or service ports that have been used the most

and the amount of traffic for the most used protocols or service ports.

Host IP Address displays the LAN, DMZ or WLAN IP addresses to and /or from

which the most traffic has been sent and how much traffic has been sent to and from

those IP addresses.

Click Refresh to update the report display. The report also refreshes automatically

when you close and reopen the screen.

Click Flush to discard the old report data and update the report display.

ZyWALL 2 Plus User's Guide

Troubleshooting