Log Command Example - ZyXEL Communications ZYWALL 2 PLUS User Manual

Log Command Example

This example shows how to set the ZyWALL to record the access logs and alerts and then
view the results.
ras> sys logs load
ras> sys logs category access 3
ras> sys logs save
ras> sys logs display access
# .time
message
0|06/08/2004 05:58:21 |172.21.4.154
BLOCK
Firewall default policy: IGMP (W to W/ZW)
1|06/08/2004 05:58:20 |172.21.3.56
BLOCK
Firewall default policy: IGMP (W to W/ZW)
2|06/08/2004 05:58:20 |172.21.0.2
BLOCK
Firewall default policy: IGMP (W to W/ZW)
3|06/08/2004 05:58:20 |172.21.3.191
BLOCK
Firewall default policy: IGMP (W to W/ZW)
4|06/08/2004 05:58:20 |172.21.0.254
BLOCK
Firewall default policy: IGMP (W to W/ZW)
5|06/08/2004 05:58:20 |172.21.4.187:137
BLOCK
Firewall default policy: UDP (W to W/ZW)
Routing Command
Syntax:
ip nat routing [0:LAN|1:DMZ|2:WLAN] [0:no|1:yes]
Use this command to set the ZyWALL to route traffic that does not match a NAT rule through
a specific interface. An example of when you may want to use this is if you have servers with
public IP addresses connected to the LAN, DMZ or WLAN. By default the ZyWALL routes
traffic that does not match a NAT rule out through the DMZ interface.
The following command example sets the ZyWALL to route traffic that does not match a
NAT rule through the WLAN interface.
ZyWALL 2 Plus User's Guide
source
Appendix G Command Interpreter
destination
|224.0.1.24
|239.255.255.250
|239.255.255.254
|224.0.1.22
|224.0.0.1
|172.21.255.255:137
notes
|ACCESS
|ACCESS
|ACCESS
|ACCESS
|ACCESS
|ACCESS
641