Pppoe Encapsulation - ZyXEL Communications ZYWALL 2 PLUS User Manual

Table 189 Menu 11.1: Remote Node Profile for Ethernet Encapsulation (continued)
FIELD
Server
Relogin Every
(min)
Route
Edit IP
Session Options
Schedules
Edit Filter Sets
Edit Traffic
Redirect
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

33.3.2 PPPoE Encapsulation

The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use
PPPoE encapsulation when you're using the ZyWALL with a DSL modem as the WAN
device. If you change the Encapsulation to PPPoE, then you will see the next screen.
ZyWALL 2 Plus User's Guide
DESCRIPTION
This field is valid only when RoadRunner is selected in the Service Type field. The
ZyWALL will find the RoadRunner Server IP automatically if this field is left blank. If
it does not, then you must enter the authentication server IP address here.
This field is available when you select Telia Login in the Service Type field.
The Telia server logs the ZyWALL out if the ZyWALL does not log in periodically.
Type the number of minutes from 1 to 59 (30 recommended) for the ZyWALL to wait
between logins.
This field refers to the protocol that will be routed by your ZyWALL – IP is the only
option for the ZyWALL.
This field leads to a "hidden" menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.1.2 - Remote Node Network Layer Options.
You can apply up to four schedule sets here. For more details please refer to
Chapter 43 on page 575.
This field leads to another "hidden" menu. Use [SPACE BAR] to select Yes and
press [ENTER] to open menu 11.x.4 to edit the filter sets. See
494 for more details.
Press [SPACE BAR] to select Yes or No.
Select No (default) if you do not want to configure this feature. Select Yes and press
[ENTER] to configure Menu 11.1.5 - Traffic Redirect Setup.
Chapter 33 Remote Node Setup
Section 33.5 on page
489