Using The Ftp Command From The Dos Prompt Example; Figure 174 Menu 24.7.2 System Maintenance: Upload System Configuration File - ZyXEL Communications G-3000 User Manual

Chapter 25 Firmware and Configuration File Maintenance

Figure 174 Menu 24.7.2 System Maintenance: Upload System Configuration File

Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and SMT
as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename" is the name of
your system configuration file on your workstation, which will be transferred to the
"rom-0" file on the system.
4. The system reboots automatically after the upload system configuration file process
is complete.
For details on FTP commands, please consult the documentation of your FTP client
program. For details on uploading system firmware using TFTP (note that you must
remain on this menu to upload system firmware using TFTP), please see your manual.
Press ENTER to Exit:
To transfer the firmware and the configuration file, follow these examples:

25.4.3 Using the FTP command from the DOS Prompt Example

1 Launch the FTP client on your computer.
2 Enter "open" and the IP address of your ZyXEL Device.
3 Press [ENTER] when prompted for a username.
4 Enter your management password as requested. The default is 1234.
5 Enter "bin" to set transfer mode to binary.
6 Use "put" to transfer files from the computer to the ZyXEL Device for example "put
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the ZyXEL
Device and renames it "ras". Similarly "put config.rom rom-0" transfers the
configuration file on your computer (config.rom) to the ZyXEL Device and renames it
"rom-0". Likewise "get rom-0 config.rom" transfers the configuration file on the ZyXEL
Device to your computer and renames it "config.rom." See earlier in this chapter for
more information on filename conventions.
7 Enter "quit" to exit the FTP prompt.
244
password
G-3000 Series User's Guide