Wireless Lan Setup; Figure 140 Menu 3.5 Wireless Lan Setup; Table 71 Menu 3.2 Tcp/Ip Setup - ZyXEL Communications G-3000 User Manual

Chapter 19 LAN Setup
Follow the instructions in the following table on how to configure the fields in this menu.

Table 71 Menu 3.2 TCP/IP Setup

FIELD
IP Address
Assignment
IP Address
IP Subnet Mask
Gateway IP
Address
When you have completed this menu, press [
save your configuration, or press [

19.3 Wireless LAN Setup

Use menu 3.5 to set up your ZyXEL Device as the wireless access point. To edit menu 3.5,
enter 3 from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5
and then press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next.

Figure 140 Menu 3.5 Wireless LAN Setup

WLAN Adapter= Built-in
Operating Mode= AP + Bridge
Hide Name (SSID)= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
210
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select Dynamic to have the ZyXEL
Device obtain an IP address from a DHCP server. You must know the IP address
assigned to the ZyXEL Device (by the DHCP server) to access the ZyXEL Device
again.
Select Static to give the ZyXEL Device a fixed, unique IP address. Enter a subnet
mask appropriate to your network and the gateway IP address if applicable.
Enter the (LAN) IP address of your ZyXEL Device in dotted decimal notation
Your ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device.
Type the IP address of the gateway. The gateway is an immediate neighbor of your
ZyXEL Device that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same network segment as your ZyXEL Device.
ENTER
ESC
] at any time to cancel.
Menu 3.5 - Wireless LAN Setup
Press ENTER to Confirm or ESC to Cancel:
] at the prompt "Press ENTER to Confirm..." to
Edit MAC Address Filter= No
Edit Roaming Configuration= No
Edit SSID Profile= N/A
Public SSID Profile = N/A
Select SSID Profile= SSID01
Edit Bridge Link Configuration= No
Preamble= Dynamic
802.11 Mode= Mixed
Max. Frame Burst= 650
Breathing LED= Yes
Block Intra-BSS Traffic= No
Output Power= 100%(Full Power)
Edit Layer-2 Isolation= No
G-3000 Series User's Guide