Using The Ftp Command From The Dos Prompt Example; Figure 109 Menu 24.7.2 System Maintenance: Upload System Configuration File - ZyXEL Communications ZyAIR G-5100 User Manual

ZyAIR G-5100 User's Guide

Figure 109 Menu 24.7.2 System Maintenance: Upload System Configuration File

Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and SMT
as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename" is the name of
your system configuration file on your workstation, which will be transferred to the
"rom-0" file on the system.
4. The system reboots automatically after the upload system configuration file process
is complete.
For details on FTP commands, please consult the documentation of your FTP client
program. For details on uploading system firmware using TFTP (note that you must
remain on this menu to upload system firmware using TFTP), please see your manual.
Press ENTER to Exit:
To transfer the firmware and the configuration file, follow these examples:

20.4.3 Using the FTP command from the DOS Prompt Example

1 Launch the FTP client on your computer.
2 Enter "open" and the IP address of your ZyAIR.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested. The default is 1234.
5 Enter "bin" to set transfer mode to binary.
6 Use "put" to transfer files from the computer to the ZyAIR, e.g., put firmware.bin ras
transfers the firmware on your computer (firmware.bin) to the ZyAIR and renames it
"ras". Similarly "put config.rom rom-0" transfers the configuration file on your computer
(config.rom) to the ZyAIR and renames it "rom-0". Likewise "get rom-0 config.rom"
transfers the configuration file on the ZyAIR to your computer and renames it
"config.rom." See earlier in this chapter for more information on filename conventions.
7 Enter "quit" to exit the FTP prompt.
176 Chapter 20 Firmware and Configuration File Maintenance
password