Chapter 21 VLAN Setup
Figure 153 Menu 16 VLAN Setup
--------------------------------------------------------------
1. Active= N/A
2. Active= N/A
3. Active= N/A
4. Active= N/A
5. Active= N/A
6. Active= N/A
7. Active= N/A
8. Active= N/A
9. Active= N/A
10.Active= N/A
11.Active= N/A
12.Active= N/A
13.Active= N/A
14.Active= N/A
15.Active= N/A
16.Active= N/A
--------------------------------------------------------------
The following table describes the fields in this menu.
Table 79 Menu 16 VLAN Setup
FIELD
VLAN Tagging
Native VLAN ID
Active
ID
Name
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
224
Menu 16 - VLAN Setup
VLAN Tagging= No
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
ID= N/A
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
To enable VLAN tagging, press [SPACE BAR] to select Yes and press
[ENTER].
Enter a number from 1 to 4094. At least one device in your network must
belong to this VLAN group in order to manage the ZyXEL Device.
Mail and FTP servers must have the same management VLAN ID to
communicate with the ZyXEL Device.
Use this table to map names to VLAN IDs so that the RADIUS server can
assign each user or user group a mapped VLAN ID. See your RADIUS server
documentation for more information on configuring VLAN ID attributes.
See
Section 15.2.3 on page 178
To enable a SSID to VLAN mapping entry, press [SPACE BAR] to select Yes
and press [ENTER].
Enter a number from 1 to 4094 to define this VLAN group.
Type a name to have the ZyXEL Device check for specific VLAN attributes on
incoming messages from the RADIUS server. Access-accept packets sent by
the RADIUS server contain VLAN related attributes. The configured Name
fields are checked against these attributes. If a configured Name field
matches these attributes, the corresponding VLAN ID is added to packets
sent from this user to the LAN.
If the VLAN-related attributes sent by the RADIUS server do not match a
configured Name field, a wireless station is assigned the wireless VLAN ID
associated with its SSID.
Native VLAN ID=N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
Name= N/A
for more information.
G-3000 Series User's Guide