System Timeout; Configuring Telnet; Figure 67 Remote Management: Telnet; Table 37 Remote Management: Telnet - ZyXEL Communications G-3000 User Manual

Chapter 11 Remote Management Screens

11.1.2 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The ZyXEL Device automatically logs you out if the management session remains idle for
longer than this timeout period. The management session does not time out when a statistics
screen is polling. You can change the timeout period in the System > General screen (see
Section 5.2 on page

11.2 Configuring Telnet

You can configure your ZyXEL Device for remote Telnet access. Use this screen to specify
which interfaces allow Telnet access and from which IP address the access can come.
Click REMOTE MGNT and the TELNET tab to display the screen as shown.

Figure 67 Remote Management: Telnet

The following table describes the labels in this screen.

Table 37 Remote Management: Telnet

LABEL
TELNET
Server Port
Server
Access
Secured
Client IP
Address
Apply
Reset
128
67).
You can change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyXEL Device
using Telnet.
A secured client is a "trusted" computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
G-3000 Series User's Guide