Command Syntax; Command Usage; Brute-Force Password Guessing Protection; Configuring Brute-Force Password Guessing Protection: Example - ZyXEL Communications G-3000 User Manual

Chapter 26 System Maintenance and Information

Figure 181 Valid CI Commands

Copyright (c) 1994 - 2005 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
certificates
radserv
ras>

26.1.1 Command Syntax

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.

26.1.2 Command Usage

A list of valid commands can be found by typing help or ? at the command prompt. Always
type the full command. Type exit to return to the SMT main menu when finished.

26.1.3 Brute-Force Password Guessing Protection

The following describes the commands for enabling, disabling and configuring the brute-force
password guessing protection mechanism for the password.

Table 88 Brute-Force Password Guessing Protection Commands

COMMAND
sys pwderrtm
sys pwderrtm 0
sys pwderrtm N

26.1.3.1 Configuring Brute-Force Password Guessing Protection: Example

sys pwderrtm 5
This command sets the password protection to block all access attempts for five minutes after
the third time an incorrect password is entered.
250
exit ether
8021x
wcfg
DESCRIPTION
This command displays the brute-force guessing password protection settings.
This command turns off the password's protection from brute-force guessing. The
brute-force password guessing protection is turned off by default.
This command sets the password protection to block all access attempts for N (a
number from 1 to 60) minutes after the third time an incorrect password is entered.
wlan ip
G-3000 Series User's Guide
bridge