Figure 79 Remote Management: Snmp; Table 42 Remote Management: Snmp - ZyXEL Communications G-3000 User Manual

Chapter 11 Remote Management Screens

Figure 79 Remote Management: SNMP

The following table describes the labels in this screen.

Table 42 Remote Management: SNMP

LABEL
SNMP Configuration
Get Community
Set Community
Community
Destination
SNMP
Service Port
Service Access
Secured Client IP
Address
Apply
Reset
140
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Enter the Set community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
A secured client is a "trusted" computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the ZyXEL Device using this service.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
G-3000 Series User's Guide