Using The Ftp Command From The Dos Prompt; Figure 166 Ftp Session Example; Table 86 General Commands For Third Party Ftp Clients - ZyXEL Communications G-3000 User Manual

25.2.2 Using the FTP Command from the DOS Prompt

1 Launch the FTP client on your computer.
2 Enter "open" and the IP address of your ZyXEL Device.
3 Press [ENTER] when prompted for a username.
4 Enter your management password as requested. The default is 1234.
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the ZyXEL Device to the computer, for example, "get
rom-0 config.rom" transfers the configuration file on the ZyXEL Device to your
computer and renames it "config.rom". See earlier in this chapter for more information
on filename conventions.
7 Enter "quit" to exit the FTP prompt.

Figure 166 FTP Session Example

The following table describes some of the commands that you may see in third party FTP
clients.

Table 86 General Commands for Third Party FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote
Directory
Initial Local Directory Specify the default local directory (path).
G-3000 Series User's Guide
Chapter 25 Firmware and Configuration File Maintenance
C:\>ftp
ftp> open 192.168.1.2
Connected to 192.168.1.2.
220 G-3000 FTP version 1.0 ready at Sat Jan
00:03:09 2000
User (192.168.1.2:(none)):
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
1
239