Using The Ftp Command From The Dos Prompt Example; Figure 17-6 Menu 24.7.2 System Maintenance : Upload System Configuration File - ZyXEL Communications Wireless Access Point ZyAIR B-500 User Manual

ZyAIR B-500 Wireless Access Point User's Guide
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload the system configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your system configuration file on your workstation, which
will be transferred to the "rom-0" file on the system.
4. The system reboots automatically after the upload system configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.

Figure 17-6 Menu 24.7.2 System Maintenance : Upload System Configuration File

To transfer the firmware and the configuration file, follow these examples:

17.4.3 Using the FTP command from the DOS Prompt Example

Step 1. Launch the FTP client on your computer.
Step 2. Enter "open" and the IP address of your ZyAIR.
Step 3. Press [ENTER] when prompted for a username.
Step 4. Enter "root" and your SMT password as requested. The default is 1234.
Step 5. Enter "bin" to set transfer mode to binary.
Step 6. Use "put" to transfer files from the computer to the ZyAIR, e.g., put firmware.bin ras transfers
the firmware on your computer (firmware.bin) to the ZyAIR and renames it "ras". Similarly "put
config.rom rom-0" transfers the configuration file on your computer (config.rom) to the ZyAIR
and renames it "rom-0". Likewise "get rom-0 config.rom" transfers the configuration file on the
ZyAIR to your computer and renames it "config.rom." See earlier in this chapter for more
information on filename conventions.
Step 7. Enter "quit" to exit the FTP prompt.
17-8
Press ENTER to Exit:
Firmware and Configuraiton File Maintenance