Configuring Roaming; Figure 143 Menu 3.5 Wireless Lan Setup; Table 73 Menu 3.5.1 Wlan Mac Address Filter - ZyXEL Communications G-3000 User Manual

Chapter 19 LAN Setup
The following table describes the fields in this menu.

Table 73 Menu 3.5.1 WLAN MAC Address Filter

FIELD
Active
Filter Action
MAC Address Filter
1..32
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

19.3.2 Configuring Roaming

The roaming feature allows wireless LAN users to move between the coverage areas of
different access points in a wireless LAN.
Follow the steps below to configure roaming on your ZyXEL Device.
1 From the main menu, enter 3 to open Menu 3 – LAN Setup.
2 Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Figure 143 Menu 3.5 Wireless LAN Setup

WLAN Adapter= Built-in
Operating Mode= Access Point
Hide Name (SSID)= No
Channel ID= CH06 2437MHz
RTS Threshold= 2432
Frag. Threshold= 2432
214
DESCRIPTION
To enable MAC address filtering, press [SPACE BAR] to select Yes and press
[ENTER].
Define the filter action for the list of MAC addresses in the MAC address filter
table.
To deny access to the ZyXEL Device, press [SPACE BAR] to select Deny
Association and press [ENTER]. MAC addresses not listed will be allowed to
access the router.
The default action, Allowed Association, permits association with the ZyXEL
Device. MAC addresses not listed will be denied access to the router.
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the client
computers that are allowed or denied access to the ZyXEL Device in these
address fields.
Menu 3.5 - Wireless LAN Setup
Press ENTER to Confirm or ESC to Cancel:
Edit MAC Address Filter= No
Edit Roaming Configuration= No
Edit SSID Profile= N/A
Public SSID Profile = N/A
Select SSID Profile= SSID01
Edit Bridge Link Configuration= N/A
Preamble= Dynamic
802.11 Mode= Mixed
Max. Frame Burst= 650
Breathing LED= Yes
Block Intra-BSS Traffic= No
Output Power= 100%(Full Power)
Edit Layer-2 Isolation= No
G-3000 Series User's Guide