Savin IS200e Operating Instructions Manual page 78

Configuring the Scanner Settings
• Pressing [New Job] finishes the current scanning job and sends the
scanned data. You can start a new job with the current settings after the
scanned data is sent.
• Pressing [OK] finishes the current scanning job, sends the scanned data,
and then returns to the initial screen when the power is turned on.
When scanning is performed from the exposure glass
The following screen appears when you press [Finish] after scanning the
original on the exposure glass.
3
• Pressing [New Job] finishes the current scanning job and sends the
scanned data. You can start a new job with the current settings after the
scanned data is sent.
• Pressing [OK] finishes the current scanning job, sends the scanned data,
and then returns to the initial screen when the power is turned on.
Note
❒ You can specify the time during which the screen for selecting the next
operation remains displayed using [Configuration] → [Basic Settings] →
[Scanner] → [Wait Time for Additional Scanning] on the Web Status Monitor.
See the Web Status Monitor Help.
❒ When you perform an [Enter Custom Send File] operation from the Web
Status Monitor, selecting [New Job] and [OK] on the selection screen both
finishes the current scanning job, sends the scanned data, and the [Enter
Custom Send File] settings are retained. Press [PrevMenu] to return to the
initial screen when the power is turned on.
• Clear Settings after Each Scan Job
The initial screen displayed immediately after power-on appears on the
display panel of this machine, and files are sent.
Note
❒ When you perform the [Enter Custom Send File] operation from the Web
Status Monitor, the [Enter Custom Send File] settings are retained after
files are sent. Press [PrevMenu] to return to the initial screen when the
power is turned on.
❖ ❖ ❖ ❖ Erase Border
When you perform a scan operation, it may happen that a borderline is repro-
duced on scan data by the shadow of paper ends of the original. This machine
can erase the borderline using a white line, which width you can specify us-
ing [Erase Border]. You can select a line width from 1mm (0.04") to 5mm (0.2").
Select "0mm" if you do not want to have the borderline erased. The option se-
lected for this item applies scanning performed in a Send Scan (Delivery Serv-
er or Send Mail/Send File) operation.
68