Performing Scan Operation; Starting A Scan Operation; To Start With Originals In The Adf - Savin IS200e Operating Instructions Manual

Performing Scan Operation

Starting a Scan Operation

To start with originals in the ADF

A A A A
Confirm that the E-mail Ready
screen is displayed.
When "
Select destination(s).
is displayed, no destination is select-
ed. Select a destination to display
" " on the screen.
Ready
B B B B
Press the { { { { Start} } } } key.
Scanning originals in the ADF
starts.
Note
❒ To interrupt scanning, press the
{ { { { Clear/Stop} } } } key.
❒ When "
Show
Each Scan Job
[End of Scan Option] under [2.Send
Scan Settings], a screen for select-
ing the next operation appears
after scanning of all the originals
in the ADF is completed.
"
AFJ044S
Options after
" is selected for
Performing Scan Operation
• Press [Add] to continue scan-
ning to add scanned data to
the current image file.
• Press [New Job] to finish the
current scanning job and
send the scanned data. You
can start a new job with the
current settings after the
scanned data is sent.
• Press [OK] to finish the cur-
rent scanning job, send the
scanned data, and then re-
turn to the initial screen
when the power is turned on.
If you do not press any key,
this machine acts as [OK] is
pressed, after the specified
period.
When scanning finishes properly,
the e-mail is sent to the e-mail
(SMTP) server. B appears at the
upper right corner of the screen
while the e-mail is sent.
Note
❒ You cannot perform any opera-
tions while B is displayed on
the screen.
❒ Do not turn the power of this
machine off while B is dis-
played on the screen.
B disappears when the E-mail has
been sent to the E-mail (SMTP)
server, and the E-mail standby
screen appears.
5
141