Attaching the Ferrite Core for the Network Cable
Important
❒ Use a 100BASE-TX (category 5) or 10BASE-T network cable when you con-
nect this machine to a network.
A A A A
With the network cable you use for connection, create a single loop in a dis-
tance shown in A A A A on the both ends of the cable. Attach the ferrite core that
comes with this machine as illustrated below.
About 7.5cm(3") for the scanner side end. About 5.5cm(2.2") for the network
side end.
B B B B
Insert the network cable's end into the network interface connector of this
machine.
C C C C
Insert the other end of the network cable into an appropriate connector of
a network device, such as an Ethernet hub.
Attaching the Ferrite Core for the Keyboard
A A A A
Attach the ferrite core about 17cm(6.8")(B B B B ) away from the end of the cable
of the USB keyboard.
B B B B
Connect the USB keyboard cable to either one of the USB ports of the USB
interface card.
AEV047S
AJH001S