Savin IS200e Operating Instructions Manual page 68

Configuring the Scanner Settings
C Specify the IP address of this
machine.
• Input the IP address using
the number keys.
• An IP address consists of four
parts, and each part has a
3
number within the range of 0
to 255. Make sure that you in-
put each part of the IP ad-
dress in three digits. For
example, when you want to
specify "8" for a part, high-
light the part and then input
"008" using the number keys.
You can use { { { { 1 1 1 1 } } } } (or { { { { #} } } } )
and { { { { 0 0 0 0 } } } } keys to move the
highlighting to right and left.
Note
❒ You can use the { { { { Clear/Stop} } } }
key to clear the three-digit
number currently highlighted.
D When you are finished, press
[OK].
This returns to the System Set-
tings menu.
Note
❒ Pressing [Cancel] discards the
value that you have speci-
fied, and returns to the previ-
ous screen.
E Press [↓ ↓ ↓ ↓ Next]
"3. Subnet Mask" appears as the
setup item currently selected.
F Specify each value for "3. Sub-
net Mask", "4. Default Gateway
Address", "5. Access Control"
and "6. Access Mask" in the
same way that you have done in
steps B B B B through E E E E .
"7. Network Boot" appears as the
setup item currently selected.
58
Note
❒ When you want to set no lim-
itation of access to this ma-
chine, it is not necessary to
specify "5. Access Control",
while you need to confirm
that "6. Access Mask" is set
to "000.000.000.000".
G Press [Settings].
The setting screen for "7. Net-
work Boot" appears.
H Use [↑ ↑ ↑ ↑ ] and [↓ ↓ ↓ ↓ ] to display
"NONE".
Note
❒ "*" mark appears along with
the option currently selected.
I While "NONE" is displayed,
press [OK].
This returns to the System Set-
tings menu.
Note
❒ Pressing [Cancel] leaves the
setting as it was (the option
marked with "*" remains ac-
tive), and returns to the pre-
vious screen.